隐形矫治中不同附件及位置矫治扭转尖牙的三维有限元分析

doi:10.13591/j.cnki.kqyx.2022.05.013

摘要/Abstract

摘要： 目的通过三维有限元法比较不同附件以及不同放置位置对隐形矫治器矫正左上颌尖牙扭转的影响。方法通过扫描数据分别建立矫治器-附件-尖牙-牙周膜-松质骨-皮质骨(有附件组)与(无附件组)有限元模型。其中有附件组中的附件分为垂直矩形附件、垂直楔形附件、优化扭转附件,放置位置又分为颊侧中1/3、远中1/3以及颊-舌侧中1/3。将各组的矫治器以尖牙牙体长轴为旋转中心轴,将矫治器远中扭转2°,在MSC.Marc.Mentat软件中模拟运算,收集各应力、位移分布云图及最大应力、位移值。结果 ①无论有无附件,尖牙位移及牙周膜应力分布趋势相似,但附件组的尖牙位移值及牙周膜各种应力值均大于无附件组;②选用相同附件情况下,放置于颊侧中1/3的应力值和最大初始位移最高,颊-舌侧放置的应力和位移表达更加高效,远中1/3放置效果相对较差。结论 ①颊面中1/3与颊-舌侧放置应力值和最大初始位移量无明显差别,但是颊-舌侧放置矫治效果更加高效,消除了不必要的倾斜移动,对固位的要求也更低。②单牙模型中垂直矩形和垂直楔形附件矫治效果显著较优化扭转附件好,实际效果有待临床进一步验证。

关键词: 隐形矫治, 附件, 扭转, 尖牙, 三维有限元分析

Abstract: Objective To compare the effect of different attachments and positions on the left maxillary canine tooth torsion in clear aligner by three-dimensional finite element analysis. Methods Finite element models of the clear aligner-attachment-maxillary canine-periodontal ligament-spongy bone-cortical bone (attachment groups and non-attachment group) were established according to the scanning data of in vitro maxillary canine. The models with attachments were divided into three groups based on different kinds of attachments, namely vertical rectangular attachment, vertical wedge-shaped attachment, optimized torsion attachment groups. The placement positions were divided into buccal middle 1/3, distal 1/3 and buccal-lingual middle 1/3. Two degrees clockwise rotation of the tooth long axis was applied to the clear aligner. Actions of the appliance and the canine were simulated and calculated by MSC.Marc.Mentat software. Then, nephograms of stress and displacement, and the maximum stress and displacement values were collected. Results ① The distribution trend of the displacement of canine and the stress of periodontal ligament was similar with or without attachments, but the displacement value of canine and the stress value of periodontal ligament in the attachment group were higher than that in the non-attachment group. ② When the same attachment was selected, the stress value and maximum initial displacement value were the highest in the buccal middle 1/3; the stress and displacement expression were more efficient in buccal-lingual middle 1/3, and the effect of the distal 1/3 was relatively bad. Conclusion ① There is no significant difference in the stress value and the maximum initial displacement between the buccal middle 1/3 and the buccal-lingual middle 1/3, but the buccal-lingual middle 1/3 is more efficient, eliminating unnecessary tipping movement and requiring less retention. ② The orthodontic effect of vertical rectangular and vertical wedge-shaped attachments in one tooth model is significantly better than that of optimized torsion attachments. The actual effect needs further clinical verification.

Key words: clear aligner, attachment, torsion, canine, three-dimensional finite element analysis

中图分类号:

R783.5

雷泽华, 杜庆玲, 邹明媛, 余飞, 林新平. 隐形矫治中不同附件及位置矫治扭转尖牙的三维有限元分析[J]. 口腔医学, 2022, 42(5): 451-455.

LEI Zehua, DU Qingling, ZOU Mingyuan, YU Fei, LIN Xinping. Three-dimensional finite element analysis of torsional canines treated with different attachments and positions in clear aligner[J]. Stomatology, 2022, 42(5): 451-455.

参考文献

[1] 赵志河. 无托槽隐形矫治的风险及临床策略[J]. 中华口腔医学杂志, 2019, 54(12):798-802.
[2] Charalampakis O, Iliadi A, Ueno H, et al. Accuracy of clear aligners: A retrospective study of patients who needed refinement[J]. Am J Orthod Dentofac Orthop, 2018, 154(1):47-54.
[3] Robertson L, Kaur H,Fagundes NCF, et al. Effectiveness of clear aligner therapy for orthodontic treatment: A systematic review[J]. Orthod Craniofac Res, 2020, 23(2):133-142.
[4] Kravitz ND, Kusnoto B, Agran B, et al. Influence of attachments and interproximal reduction on the accuracy of canine rotation with Invisalign. A prospective clinical study[J]. Angle Orthod, 2008, 78(4):682-687.
[5] 普盼君, 封颖丽, 任亚男, 等. 无托槽隐形矫治牙齿旋转效率的研究[J]. 中华口腔正畸学杂志, 2019, 26(2):85-89.
[6] 王琰玲. 自然牙列下颌侧方咬合运动中牙合接触特征的研究[D]. 南京: 南京医科大学, 2007.
[7] 张凤丹, 张军梅. 无托槽隐形矫治技术附件的发展及应用[J]. 全科口腔医学电子杂志, 2016, 3(15):12-14, 16.
[8] 田姗璨, 白蕊, 徐晓梅, 等. 上颌尖牙在无托槽隐形矫治中伸长运动的三维有限元分析[J]. 中国组织工程研究, 2019, 23(10):1489-1495.
[9] Cai YQ, Yang XX, He BW, et al. Numerical analysis of tooth movement in different plans of transparent tooth correction therapies[J]. Technol Health Care, 2015, 23(3):299-305.
[10] Hemanth M,Deoli S, Raghuveer HP, et al. Stress induced in the periodontal ligament under orthodontic loading (part I):A finite element method study using linear analysis[J]. J Int Oral Health, 2015, 7(8):129-133.
[11] 吴稀, 韦代伦, 周容, 等. 两种舌侧托槽垂直向控制性能三维有限元分析[J]. 安徽医科大学学报, 2018, 53(2):312-315.
[12] Simon M,Keilig L, Schwarze J, et al. Treatment outcome and efficacy of an aligner technique-regarding incisor torque, premolar derotation and molar distalization[J]. BMC Oral Heal, 2014, 14: 68.
[13] 高洁. 无托槽隐形矫治器圆锥形前磨牙旋转移动的三维有限元分析[D]. 兰州: 兰州大学, 2020.
[14] Cai YQ, Yang XX, He BW, et al. Finite element method analysis of the periodontal ligament in mandibular canine movement with transparent tooth correction treatment[J]. BMC Oral Health, 2015, 15: 106.
[15] 谢金辰. SmartTrack矫正扭转前牙的效能及其影响因素的最优尺度回归分析[D].南昌:南昌大学,2019.
[16] 吴雪, 何淞, 杨钦佩, 等. 双槽沟被动自锁系统扭转性能的三维有限元分析[J]. 口腔医学研究, 2017, 33(1):42-46.
[17] Kravitz ND, Kusnoto B, BeGole E, et al. How well does Invisalign work? A prospective clinical study evaluating the efficacy of tooth movement with Invisalign[J]. Am J Orthod Dentofacial Orthop, 2009, 135(1):27-35.
[18] Chenin DA, Trosien AH, Fong PF, et al. Orthodontic treatment with a series of removable appliances[J]. J Am Dent Assoc, 2003, 134(9):1232-1239.
[19] 刘妍. 无托槽隐形矫治临床应用的优势与不足[J]. 中华口腔医学杂志, 2017, 52(9):538-542.