饵激光预备及光固化灯超强功率模式对树脂微渗漏的影响

›› 2016, Vol. 36 ›› Issue (5): 403-406.

饵激光预备及光固化灯超强功率模式对树脂微渗漏的影响

罗瑞¹,陈亚明²

1. 南京医科大学附属口腔医院综合科
2. 南京医科大学附属口腔医院

收稿日期:2015-12-23 修回日期:2016-01-19 出版日期:2016-05-28 发布日期:2016-06-01
通讯作者: 陈亚明 E-mail:yaming_chen@njmu.edu.cn
基金资助:
江苏高校优势学科建设工程资助项目

The effect of Er: YAG laser preparation and xtra power mode of curing light on the microleakage of the composite resin

¹,

Received:2015-12-23 Revised:2016-01-19 Online:2016-05-28 Published:2016-06-01

摘要/Abstract

摘要： 目的研究饵激光备洞和光固化灯超强功率模式对树脂充填微渗漏的影响。方法将40颗离体后牙随机平均分成4组进行备洞和充填固化：A高速涡轮机加安福士椅旁LED灯（550 mW/cm2，20 s）；B组高速涡轮机加VALO光固化灯（超强功率模式3200 mW/cm2，3 s）；C组铒激光加安福士椅旁LED灯；D组铒激光加VALO光固化灯。所有样本制备V类洞并行树脂充填后置于37℃生理盐水中24 h，冷热循环后亚甲基蓝溶液染色，在低速切割机下颊舌向切开，体式显微镜下观察剖面微渗漏情况，计分，统计。结果所有样本的龈壁微渗漏与壁相比较更高，A组微渗漏程度较B,C组低，有统计学差异（P＜0.05）。D组微渗漏最大，与其他各组有统计学差异（P＜0.05）。结论铒激光备洞和光固化灯超级功率模式都会增加树脂充填微渗漏的发生。

关键词: 铒激光超强功率模式树脂微渗漏

Abstract: Objective To study the effect of Er: YAG laser preparation and xtra power mode of curing light on the microleakage of the composite resin filling. Methods 40 extracted molars were randomly divided into 4 groups for cavity preparation, filling and curing: Group A—High speed handpiece and ANTHOS therapy unit attached LED light (550 mW/cm2, 20 s); Group B—high speed handpiece and VALO light curing unit (xtra power mode 3200 mW/cm2, 3 s ); Group C—Er: YAG laser and ANTHOS therapy unit attached LED light; Group D—Er: YAG laser and VALO light curing unit. All the samples were prepared for class V cavities thereupon resin filling and placed in the normal saline at 37 ℃ for 24 h. After thermocycling, all samples were stained by methylene blue solution, and then sectioned longitudinally in buccolingual direction. Microleakage of the composite resin was observed under stereomicroscope and statistically analyzed. Results Microleakage of gingival wall in all samples was higher than that of the occlusal wall; Microleakage of group A was lower than in group B and group C, with a statistically significant difference (P ＜ 0.05). Group D had the largest microleakage compared with other groups, and the difference was statistically significant (P＜0.05). Conclusion The Er: YAG laser preparation and xtra power mode of the light curing unit will increase the risk of the resin filling leakage.

Key words: Er:YAG laser xtra power mode resin microleakage

中图分类号:

R781.05

罗瑞陈亚明. 饵激光预备及光固化灯超强功率模式对树脂微渗漏的影响[J]. , 2016, 36(5): 403-406.

参考文献

[1] Keller U,Hibst R.Tooth pulp reaction following Er:YAG laser application[J]. Proc Spie,1991:127-133
[2]Bahrololoomi Z,Heydari E.Assessment of tooth preparation via Er: YAG laser and bur on microleakage of dentin adhesives[J].J DentTehran,2014,11(2):172-178
[3]Munro GA,Hilton TJ,Hermesch CB.In vitro microleakage of etched and rebonded Class 5 composite resin restorations[J].Oper Dent,1996,21(5):203-208
[4]张晓燕，吴凤鸣.激光预处理牙本质对树脂粘结性能影响的研究进展[J].口腔医学,2015,35(1):76-80
[5]Ceballo L,Toledano M,Osorio R,et al.Bonding to Er-YAG-laser-treated dentin[J].J Dent Res,2002,81(2):119-122
[6]陈燕,杨明华,李晓玲,等.Er:YAG激光备洞与树脂充填微渗漏的实验研究[J].口腔医学研究,2011,27(11):1005-1007
[7]Yaman B C,Efes B G,D?rter C,et al.Microleakage of repaired class V silorane and nano-hybrid composite restorations after preparation with erbium:yttrium–aluminum–garnet laser and diamond bur[J].Lasers Med Sci,2011,26(2):163-170
[8]Ghandehari M,Mighani G,Shahabi S,et al.Comparison of microleakage of Gglass ionomer restoration in primary teeth prepared by Er: YAG laser and the conventional method[J].J DentTehran,2012,9(3):215-220
[9]谢窈,张笋,葛立宏.乳牙应用Er:YAG激光备洞充填微渗漏效果的离体研究[J].北京大学学报：医学版,2014,46(3):474-477
[10]李金恒,朱亚琴.Er∶YAG激光预备及酸蚀处理对复合树脂充填体微渗漏的影响[J].口腔材料器械杂志,2014,23(1):15-19
[11]林琼光,张成飞,尹兴喆,等.Er,Cr:YSGG激光和酸蚀处理牙本质表面后的扫描电镜观察[J].现代口腔医学杂志,2005,19(2):168-171
[12]Wegehaupt FJ,Taub?ck TT,Sener B,et al.nfluence of light-curing mode on the erosion preventive effect of three different resin-based surface sealants[J].Int J Dent,2012,2012(12):874359-874359
[13]Braga RR,Ballester RY,Ferracane JL.Factors involved in the development of polymerization shrinkage stress in resin-composites: A systematic review[J].Dent Mater,2005,21(10):962-970
[14]Baysal A,Uysal T,Ulker M,et al.Effects of high-intensity curing lights on microleakage under bonded lingual retainers[J].Angle Orthod,2008,78(6):1084-1088
[15]秦颖,葛化冰,李金陆,等.两种光固化模式对复合树脂微渗漏的影响[J].北京口腔医学,2013,21(5):274-276
[16]Savas S,Botsali M S,Kucukyilmaz E,et al.Evaluation of temperature changes in the pulp chamber during polymerization of light-cured pulp-capping materials by using a VALO LED light curing unit at different curing distances[J].. Dent Mater J,2014,33(6):764-769